Originally Posted by
Randy_Pike
On the Rx8/Hotwire you must set the "Total" voltage you want the cut off to activate at.
okay i set the lvc to a 5s just using the unit itself. it ran fairly well but after a little flip it stopped but then after 10 secs or so it went again.
i then just held the back and made it spin wheels changing from low to high throttle after a short time it cut out. the leds were showing 4 on and qucik flash to 123 just showing the temp. if i tried to apply throttle the leds would ramp up like their meant to but nothing would happen there has to be something wrong with this. i drove it in the house last night just slowly which doesn't normally make it cut out until it stopped from lvc it showed leds 135 as it should.
so when it cuts out on the street its not the lvc any other ideas