Originally Posted by
mekios
I got my new GX5R yesterday. Today i was placing it on my Losi 8t 2.0 and i had to adjust the carb as it needs to be angled. When i finished and tried to re-screw the setting pins the screw broke!
Has anybody had the same problem?
Now i got half of the screw in the left side of the pin and i can't get it out.
Get a paneling nail and put it in and on the edge or in the middle if you can, then tap it with a hammer lightly, that should get the left side out. Then do the same with the right side and you should be good to go. I had that same problem with one of my engines. Luckily i had an extra screw laying around.