Originally Posted by WideOpenThrottle RC

This question is for the Ko Propo support staff on this forum, I'm in about my 5th month of using this radio and absolutely love it. Unfortunately this weekend at the final round of the North division RC Pro Series I experienced several loss of signals between the radio and receiver. I'm running a lipo receiver pack straight to the receiver, and when the problem occurs it's at no particular place on the track and it's similar to the failsafe being activated. If I'm turning a corner as I loose signal the tires stay in that direction for a few seconds before going straight and the throttle remains neutral. At first suspecting a bad switch twice this weekend I replaced switches, then for the pro Amain I went to a direct connection, two laps into the race I again lost signal. When the signal fails if I bring the truggy in and open the radio box the blue light on the receiver is showing power as well as the transponder, I balanced charged the lipo and my charger isn't showing any fault in either cell and it's putting out a full 8.4 volts at the end of the charge cycel. Any help would be appreciated in troubleshooting this, I love the radio but this somewhat reminds me of the issues I've had with the futaba faast system in the past and has me a bit perplexed. When this happened on the practice day I replaced the switch for the first time then ran 3 consecutive tanks and thought I had repaired it, then in the final qualifier the day after it happened again so it doesn't seem to have any rhyme or reason to the failure?