R/C Tech Forums - View Single Post - Thread pattern for servos?
Thread: Thread pattern for servos?
View Single Post
Old 08-30-2010 | 09:50 PM
  #3  
Tate72's Avatar
Tate72
Tech Master
iTrader: (52)
 
Joined: Aug 2009
Posts: 1,144
From: Indiana
Default
Originally Posted by skoalisbad4me
are you talking about the screw for the servo horn? if so yes the hitec uses a 2.6mm screw but the JR just uses a standard 3mm screw
Yep yep that would be the one. Thanks dude. Everyone that I asked local didn't know. LOL!!

I always use a little bit of locktight but always good to have extras...
Tate72 is offline  
Reply