R/C Tech Forums - View Single Post - Thread pattern for servos?
Thread: Thread pattern for servos?
View Single Post
Old 08-30-2010 | 09:24 PM
  #2  
skoalisbad4me
Tech Elite
iTrader: (162)
 
Joined: Jan 2010
Posts: 2,260
Default
Originally Posted by Tate72
Hello, I have asked the guys at the LHS and they don't know. I'm looking for the tread pattern on the JR servos.
I just read where someone said the Hitecs are 2.6mm for some reason I was thinking those were 2.2mm but I guess I was wrong.

Can someone help with the tread pattern on a Jr servo?

Thanks!!
are you talking about the screw for the servo horn? if so yes the hitec uses a 2.6mm screw but the JR just uses a standard 3mm screw
skoalisbad4me is offline  
Reply