Originally posted by SupermaxxRich
Well I've tried everything on both the second and first gears and they still wobble. I'm just going to try and run them and see what happens? The worst thing that could happen is that the teeth strip and the gears are garbage. So either way they end up in the garbage!
The aluminum 2 speed clutch housing that goes inside the second gear also wobbles a little because of the 2 speed gear wobbling. That shouldn't affect how the 2 speed clutches ingage, should it? The shoes don't rub the housing right now, but there not adjusted yet either. Let me know what you think. Thanks.
I had the same problem yesterday as well. Took it out while I was fixing my car and noticed it wobbled a bit. Tried to see what was wrong and couldnt see why it was wobbling so I just put it back again and it stip wobbling
Mine wobbled only a bit so if yours is wobbling alot then you might have a defected part. Other than that dont sweat it and run it first. I dont think mine was damaged but it does have some kind of play when its not fully tighten with the e-clip im guessing. So for me im going to put the engine back on and just run it off the ground to see if it wobbles. I think you should just slap it on and see how if it really wobbles or not with the engine running. Hope this helps.
