Originally Posted by
irgo
right after your Motor DMTS RPM reach (defined start rpm),
and at full throotle and past delay, the Supercharge will activated.
Agreed, except that I dont believe the SC activation is RPM based from the 528 manual information.
Originally Posted by
irgo
DMTS RPM is Start RPM to start your Supercharge
as your Timing (DMTS) reach it's maximum ~21° and 8000RPM
then your RPM raise again over 21°~DEG° called supercharge,
This is where we differ. As I understand it, the start of Supercharge timing is based on time delay after full throttle (setting #14) and does not begin based on a RPM level. For example:
Start RPM 8000: you begin the DMTS timing curve (as stated in the 528 manual)
After you go WOT for defined SC delay (say 0.2), the arbitrary RPM at that point, say 10000 for this example, you would begin to add in the additional SC timing to the defined DMTS timing. If you have a narrow timing window defined you get a much quicker ramp rate on the SC timing (like Tekin Turbo Ramp 3)
Jimmy