Originally Posted by
g12314
Per the SP 528 manual, this is not correct. Super Charger timing is introduced at full throttle after the setting #14 delay is past (just like Tekin). Here are the descriptions of each setting directly from the manual:
Jimmy
right after your Motor DMTS RPM reach (defined start rpm),
and at full throotle and past delay, the Supercharge will activated.
DMTS RPM is Start RPM to start your Supercharge
as your Timing (DMTS) reach it's maximum ~21° and 8000RPM
then your RPM raise again over 21°~DEG° called supercharge,
it's simple as that,
that's why near september the RPM History PC Interface
will be release by Engineer , to sure you what's is your rpm at.