I will try again
Hi all
Well, i have some issues with my Tekin/Novak Balistic 10.5 combo.
I have tried everything, FDR from 5.7 - 6.7 all combinations of timin etc etc
Should i go for RPM(high FDR or torque ( low FDR)
whatever i do, i CANT get it hotter than 50 degres C
Track 1 has a 36 meter straight, lots of turns.
Track 2 har a 45 meter straight, fast and flowing.
One thing that i can figure out, is, motor timing. On my Novak it is a N mark, this is 15* som when setup says 5, that is two mark to minus side???
Another thing, if end RPM is set to 14K instead of 20K will topspeed be the same?
Any suggestions for this two tracks?
And, is the Balistic wrong motor? should i go for an X12 instead. Seems like my buddies hwo run X12 has more RPM..
Lots of questions, but i em desperat to get a fast setup, other have Tekin and gets around a lot faster, even though we where equals before Tekin