R/C Tech Forums - View Single Post - Starter box
Thread: Starter box
View Single Post
Old 08-15-2010, 01:13 PM
  #11  
Shadowhope
Tech Adept
 
Shadowhope's Avatar
 
Join Date: Jul 2010
Location: Medina, Tennessee
Posts: 155
Default

Originally Posted by mudboger07
Just a suggestion but always preheat your mill until lat least you've ran 1 gallon of fuel threw it. without preheating it will wear faster and not last as long...

well i did heat it up a coupple of times and tried to start it whyle it was still in locked position and it still wore into the starter wheel.. so i just resorted to knocking it loose and it worked
Shadowhope is offline