Originally Posted by
Jmuck69
Double check that all your bearings are fully seated in the case halves. Second, it could be the topshaft spacer. I had to go to B4 rear axle spacer and shim accordingly. I found the topshaft spacer is a tad too long and causes it to bind when tightening down.
Yeah, I'll have to pull it apart again and double check.
Another thing just noticed is that the front wheels are either too narrow or the axles are too long, i can move the front wheels in and out about a 1/16th of an inch. The bearings kinda float in and out as well. I need to try another set of wheels first.
PS it's a FT kit.