Originally posted by Profoxcg
Add shims behing the flywheel in addition to the one 5mm that the book tell you to add. if you need an 1mm before you have 7mm then add a 1mm on top of the 5mm shim againts the engine bearing.
Thanks for your reply, I guess I wasn't clear on the exact problem. I had too small endplay (.4mm) using the instructions. Adding shims between the flywheel and the motor reduces the endplay - in my case the endplay was already too small so you need to remove the .5mm shim and replace it with a smaller one. I was able to get the endplay to .61mm by using the .30mm shim instead of the .50mm shim between the flywheel and the motor. I saw other people have the same problem as this. It's not clear in the instructions about this point, I'm wondering how critical the endplay is as I've seen some people here say that .4mm is OK, so is .4 - .7mm a good range, or do you just have to try it on the track?