Originally Posted by
losi_racer
Hey Nick i was thinking of trying these out, i currently run yeah racing lipos, only thing i dont like is i cant run the foam inside so its putting a lot of pressure on the lipo. do you run yours with foam?
Ya foam under and on the motor side of the pack and i fill the lid with the foam as well.
this is the stuff i use
http://www.amainhobbies.com/product_...er-Foam-Rubber
http://www.amainhobbies.com/product_...er-Foam-Rubber
Originally Posted by
Matt Piva
hey guys im having an issue with my low end on my engine, it seems sluggish and i think it might be cause its a lil older. i was thinking if i were to put in stiffer clutch springs then the stockers would this help the bottom? i figured if the engine engaged at a higher rpm the sluggish bottom wouldnt be as bad. i no the tune is good cause i have great smoke trail and the temps r 220 and the engines got 10 gallons on it so it deff is cause its ok. but the thing still works good mid to top.
10 gallon's...its time for a new motor......old beat/worn out motor's tend to run hot, have less and less bottom end, are usually picky to tune and have an erratic idle.....Junk it and move on.