Originally Posted by
tc5 man
i do that but the screws wont, go into the rear buckhead all the way that cant be good.
its 4.82 mm in the rear but like it said, the screws on the bottom of the rear plate dont screw in all the way and there fully tighten. the screws on the bottom go into the buckhead and are fully counterstuck.
That measurement is wrong. They're not even that thick when brand new.
Question are you trying to use a new screw in a worn chassis? If so, the screw head is not going to fully countersink. As the chassis wears out, the screws will wear too. Unless the chassis is super thin at the rear like under 2mm, you should be fine to finish out the season.