Originally Posted by
8ight-racer
Do this, take the rear of the car out and measure the thickness of the chassis where the rear toe in plate sits with a set of digital calipers and tell us how thick it is. I know some people who have Mugen's who run this chassis until it is less than 1mm thin and they cannot access the screws. DE skip plates are well worth it, front and rear!
i do that but the screws wont, go into the rear buckhead all the way that cant be good.
its 4.82 mm in the rear but like it said, the screws on the bottom of the rear plate dont screw in all the way and there fully tighten. the screws on the bottom go into the buckhead and are fully counterstuck.