Originally Posted by
spongerX
For the TC5 CVS axles your description has "This will require an Xray Hex to complete."
Is the Xray Hex being referred to the Aluminum wheel hub that the wheel mounts to?
Do the Associated TC5 CVA plastic blades fit on the end that connects to the diff or should Xray blades be used for this?
The axle has been changed to use an Xray hex, normal TC5 steering hubs and normal TC5 blades. The reason for this is that it uses a 2mm hex drive pin rather than a 1/16th and the shaft diameter is 4.94mm rather than 4.0mm.