Originally Posted by
sosidge
Build the shocks to the "normal" length, it's fine - just don't try and tighten the bottoms all the way up the thread, they won't go that far without damage! A few threads will be visible but they will be concealed by the spring cup.
Droop is normally measured to the bottom of the loop on the rear hub, and to the outer lower edge of the front wishbone. For outdoors/rubber, I would personally start at 0 rear/5 front. For carpet/rubber I would go to 1 rear/6 front.
cheers sosidge ..
im running this one indoors , for the rear droop i normaly take the rear hub off and measure on the rear arm and on the front to the c-hub ..
my photon has been going well , but last night was my 4th meeting and my worst !!! .... mostly , all fault of my own .... and not being able to concentrate ( i was knackered !! ) ... cheers