R/C Tech Forums - View Single Post - Go-Tech Engines Thread
View Single Post
Old 07-28-2010 | 01:47 AM
  #11261  
grizz1's Avatar
grizz1
Tech Elite
 
Joined: Nov 2007
Posts: 2,983
From: Auckland, New Zealand
Default

Originally Posted by 808gx7r
set you lsn stock. hsn...

start her up on the box... let her warm for a few revs... now... richen it out just continously turning out untill it will almost die when at WOT. hold wot.
now turn in your needle continously untill it just screams on the box. chuck her on the ground and go for some high speed runs on the longest strait on a track or 30-60metres and adjust hsn in hours untill you get thin smoke with nice speed.

lsn. kill it.. let her cool to room temp... fire her bak up let her warm up for a 1min!! only 1 min... now without radio on use the linkage and slowly pull it out up to full throttle (dont death rev it(go to full for less then half a second)
it should be rather boggy between 0-50% throttle lean it at an hour at a time untill it cleanly goes up. then go 1/2 an hour more on lsn
Sorry mate, but that is not tuning it when itīs hot (at normal operating temps) - not how I read it anyway. Like I said before, if it works for you good - but that is not a method I would recommend to pass onto others.
Just my honest opinion.

Last edited by grizz1; 07-28-2010 at 02:18 AM.
grizz1 is offline