Originally Posted by JAMMINKRAZY

Something is wrong. The drive shafts shouldn't even come close to popping out with any negative camber setting. Make sure your droop is set right. Front should be 110mm rear should be 127mm.



Something is wrong with linkage setup. Without the losi split diff mount, you have to be really careful when setting the linkages up. It is very common for a linkage setup to only cause a carb to bind once at running temperature.

The other thing is, carbs can develop burrs on the inside of the slide where the idle screw slots in. This happens over time when running with an improper linkage setup. You can use the edge of an hobby knife blade to remove the burrs and then follow with a scotch brite pad or very fine sand paper/emery cloth to smooth it out further. Or just replace the slide. The idle screw itself can also burr up, so that should be sanded as well.



Try the setup posted below. It will take care of ANY steering problems you have.