R/C Tech Forums - View Single Post - 8T 2.0
Thread: 8T 2.0
View Single Post
Old 07-25-2010 | 10:26 AM
  #8183  
shady3031's Avatar
shady3031
Tech Addict
iTrader: (26)
 
Joined: Sep 2006
Posts: 594
From: Birmingham, AL
Default
Originally Posted by TheFcuddy
I was adjusting the camber on the front end of my truggy. If I don't have at least -4 the drive shafts will fall out of the front diff outdrives. I have it at -6 right now just to be safe. I have the Losi aluminum hub carriers, bearings are good, toe out is 2 degrees. Is this a known issue on the T 2.0 and I am just now realizing it? The drive shafts could easily be 1-2mm longer.
Be sure to take your front hinge pins out and check them everytime I have seen a losi truck have a driveshaft pop out it has hasd a bent hinge pin, doesn't really effect performance (binding or anything) just allows the dog bone to pop out.
I have bent a few on my truck and am now using M2C hardened hinge pins.
shady3031 is offline  
Reply