R/C Tech Forums - View Single Post - Houstons Engine Service H.E.S.
Thread: Houstons Engine Service H.E.S.
View Single Post
Old 07-20-2010 | 07:15 PM
  #3512  
houston's Avatar
houston
Tech Prophet
iTrader: (96)
 
Joined: Sep 2004
Posts: 15,844
From: Sherwood,OR
Default
Originally Posted by NitroFreak2
Hey Monty,
I just picked up a p5xs that needs rebuilt, but before I send it anywere I want to check the specs on the crank.
What kind of numbers am I looking for on the rod pin and were the main and outer bearing ride? In MM or inches, either one will work.
Also, The rod that is in the motor and the extra one that came with a 4 on the wrist pin side and R on the crank end. Is this the XS or just the P5?
Thanks in advance,
Mike
any measurement under 4.92mm on the crank pin or out of round more than
.04mm is borderline and would go in my junk pile for the guy who needs a free crank at the track

the r4 rod is just as good as the r7 11th edition rod
houston is offline  
Reply