Originally Posted by
KeselowskiFan22
I just looked at my motor, and I honestly wondered "How am I supposed to get the can off?" Do I just try my best to bend the flaps away from electronics without ripping 'em off, or is there some special way I have to do this? I'm praying the first part, 'cause I don't feel like dragging out the power tools
Is your motor a closed endbell or open endbell? If it's closed then there's not much you can do. You're better off just buying a new motor, and one with an open endbell would be good
If it is an open endbell motor, then you shouldn't need to remove the can to replace the springs, get should be right on the back of the endbell...