Originally Posted by
webster420
Ok i have a novak havoc pro esc in my blitz. i have it on a tekin 7.5t motor. a traxxas water proof servo and spektrum dx3r radio. when i run it pretty wide open it runs fine. but if i run it about half throttle around my drive way just barely going it stalls and shuts the esc off and then back on and runs but only does it at half throttle. wide open its fine. i checked the gear mesh and its not to tight its good. any ideas. im stumped. i run it on a fully charged 4000mah 2s 30c lipo also.
Because I am not part of Novak's technical support group, I suggest you email
[email protected] with your question,
Our regular CS/Tech Support hours can be located here. Before emailing, take a moment to review the instructions (trouble-shooting guide) originally included with your Novak Item:
Novak Instruction Downloads
Trouble-shooting TeamNovak's One Touch™ Speed Controls
Please make your initial email as detailed as possible. Include:
~ speed control (brand/model)
~ motor (brand/wind)
~ number/type of cells
~ battery, brand (c rating/capacity
~ rotor (old/new)
~ connectors used
~ servo (brand/model)
~ radio system (receiver/transmitter)
~ vehicle & gearing
~ warranty claim?
~ lipo cut-off, on/off
~ any external modules (BEC/brand, Glitch Buster)
~ other important info: water damage, corrosive chemical sprays, excess heat, etc
The more information you provide in your first email, the more quickly tech support can offer you assistance.