I recently installed an eZRun 25A ESC in my RC18T2. It works mostly perfectly, but often times when I am moving forward, brake, reverse for a short time, then try to go forward again, it doesn't move until I either wait a long time or push it. It never does it when I am just trying to go forward from braking or a standstill, only from reverse -> forward. I have observed that when this happens, the ESC will blink both red and green very quickly, and the motor emits a quiet ticking sound at the same rate. I don't think it is a problem with my batteries or motor, because it happens with both my eZRun 7800Kv and my Tacon 4120Kv motors. My batteries are Blue LiPo 1800mAh 20C 2S's which have always balanced perfectly and charge to 8.40V every time with full capacity. Just wondering if this is a documented issue and if there is any fix to it . Thanks