R/C Tech Forums - View Single Post - 1/12 forum
Thread: 1/12 forum
View Single Post
Old 07-15-2010, 01:34 PM
  #34064  
motojon
Tech Master
iTrader: (3)
 
Join Date: Jan 2008
Location: Moreno Valley, Ca.
Posts: 1,937
Trader Rating: 3 (100%+)
Default
Originally Posted by InspGadgt
I ran the Serpent front end on my BMI for awhile. Overall the quality was very good...the machining and molding looked good with no abnormalities. Where I did have a problem was in slop...the upper arm has quite a bit of slop on the hinge pin. Also 1 of the 8/32nds adapters was not threaded all the way through. All in all though not near as much fiddling was needed to get the front end up and running as I have needed on other front ends.
yeah i hear you i had to switch to associated balls in the lower arms so i wouldnt have to modify the kingpins, simple swap though
motojon is offline  
Reply