Originally Posted by
mikedoo3
I got a used NT1 08 roller from a friend of mine and I'm trying to break in an engine, but the clutch won't engage. Wheels don't move at all with pretty high revs.
Flywheel nut is tight
gap is about .7mm
preload is 10.2 mm (10.2 from end of shaft to top of the preload nut)
clutch nut is about 9.35 mm from end of shaft
Anyone have any ideas. Thanks
Set the gap to .5, Back off the spring nut 1 full turn. When your break-in an engine you want the clutch set very light. When the engine is done; then you can set the clutch to a race tune.
Pass you soon...