Originally Posted by
ScottyTC4NZ
Hi
Can someone tell how tight the screw needs to be, so i dont bugger my servo
Jamie
New Zealand
Whats up Jamie? I have an old pic that you might find useful. Look between the servo mounts and the side of the servo, you will see a clear blob. Thats Shoe Goo.
Its applied between both mounts with the servo upside down, so that some of it can spread between the servo and chassis, and help hold the servo to the chassis when installed. Once it hardens, Shoe Goo keeps the servo from moving in its mounts.
With that said, you dont need to over tighten your servo screws to be sure it doesnt move. Just reasonably snug them down, let the Shoe Goo cure, and forget about it.