R/C Tech Forums - View Single Post - SCRT10/HYPER 10 fragility questions
Thread: SCRT10/HYPER 10 fragility questions
View Single Post
Old 06-24-2010, 03:51 PM
  #13  
onemilekyle
Tech Regular
iTrader: (1)
 
onemilekyle's Avatar
 
Join Date: Feb 2009
Location: Temecula
Posts: 257
Trader Rating: 1 (100%+)
Default
Originally Posted by losifiend
If you go with the Hyper you better stock up on front arms. Mostly lowers, and be ready to take 75% of the front end off to change them. Also carry your camber gauge with you as you will need to set camber every time you change an arm......been there. Now I'm back with the slash. Other than that its a great truck. Good luck with what ever choice you make!!
????????. 3 easy to access bolts hold on the front/rear bumper. Remove 2 screws holding the hinge pin plate. Count number of turns while screwing out pillowball. Reverse process to reinstall. Takes less then 5 minutes.

The rear is the same, but you have the bolt holding on the rear hub carrier.
onemilekyle is offline  
Reply