Originally posted by Profoxcg
I tyed to install my solie axel conversion but the pins wont fit thought the wholes on the diff... should i dremel it open a little? maybe I need instructions.. are there any posted somehwere/
The pins may be a little tight going in the hole. Perhaps it is meant to be that way. What I did was I used one of my old hex wrenches with about the same diameter as the pin and use a plastic mallet / hammer to knock the pin in. Take off the tires and lay the chassis flat while doing this. Also, make sure that the holes in the oneway outdrive and the holes in the aluminum axle is inline.