[QUOTE=Rockpyle;7570662]
Originally Posted by
Mitch-e4fs
They are TM springs and they are also the same length as the k factory ones at 23.5mm the stock TM are 21mm.
What associated shock retaining cups do i use?
Use these ones
http://www.amainhobbies.com/product_...ips-and-Cups-4
and trim off the part that goes against the shock end flush and you will be able to get ride height.
Yes, TM shock spring retainers and ball ends are short as the cup inserts into the spring retainer. If not using the TM ones, you may have too much shock length.