Originally Posted by
Barger
I changed motors and sensor cables...could the capasitor becausing it?I will wait till next week and get my mate to flash the 422 into it and see if that fixes it....apart from that it must be a speedie issue..software or hardware I am not sure...but it never got hot
I would go through the following fault finding process:
1. Put 528 back on and set as it was
2 Turn the Lipo cutoff to the off setting
3 Test the car.
If the car goes fine and does not slow down then you have a battery/connector problem or faulty esc.
If the car is just like before then you have a output problem. Probably a faulty esc or sensor wire plug.
Mike