Have a Killer10 on the way .
Will be running OD97T plug
Other than the 2045 pipe with 192 header , what other pipes have people tried with great results ?
What run times are people getting out of this motor?
Any tuning advice for this motor
and what type of life should i expect ?
Should i change the rod early on or run it till it lets go ?
Are the bearings holding up alright ?
I think that is enough questions , i've got them all covered in 1 post
I ran one with an re10 pipe and was getting around 9-30 to 10 minute in buggy.The bearings and rod hold up very well and the pinch last a long time.Myself I didn't like the 2045 it killed the power and temps went up 30 deg and got less runtime.