R/C Tech Forums - View Single Post - Capricorn LAB-C01
View Single Post
Old 06-09-2010, 07:48 PM
  #295  
rx7ttlm
Tech Elite
iTrader: (30)
 
rx7ttlm's Avatar
 
Join Date: Jul 2004
Location: Portland, OR
Posts: 2,521
Trader Rating: 30 (100%+)
Default

Originally Posted by blackyblackman
Hi!

Here is a picture with the similar parts!
You can use all XRAY NT1 parts which are marked with a red arrow!
The arrows at the shocks and diff mean the whole assembled part!
And of course fits all small, standart parts like screws, servo mount, etc.!

I do not check all items!
If i found some more, i will post it here!

You can use from NT1:
- front and rear belt
- all pulleys (except the 20T brake pulley!)
- front and rear diff
- bumper, body posts, bumper support
- front hub
- rear lower arms
- front upper arms
- swing shafts
- shocks and springs
- fuel tank
- brake pad
- pivot balls, pivot screws
- roll bar
- servo linkage



Here the same picture as .pdf in higher resolution:

XRAY NT1 Similar Parts PDF

Regards,

Michael
Hmm, that's not an xray copy at all LMAO
rx7ttlm is offline