SNIPR

iTrader: (12)

First I would like to say thank you to everyone on the O'Donnell threads for helping me with all of my questions w/ a special thank you to jer7469...

I had a lot of choices to go with when it came to a truggy. Some already setup for electric from factory & some w/ Tekno conversions, etc. I picked up mine on here for $275 shipped BNIB and that was something I couldn't pass on. The whole family of O'Donnell with all their help they have provided simply made my choice the "best" choice!

Parts that I used for this conversion:

O'Donnell Z01T
RCMonster Z01 Motor Mount
RC8e Battery Tray
ODOC2632
ODOC1545
ODOC2630
ODOQ0103

I started off by performing the team servo tray mod. You will have to cut the tray in half to clear the RCMonster motor mount. I borrowed a chassis from a Z01B and mounted it to the bottom of my truggy chassis and drilled out the holes for the new team servo tray.The Associated RC8e battery tray is an almost direct fit however, I did have to trim the front area to clear the front chassis brace. The rest is pretty much self explanatory.