Originally Posted by
gosharpie97
Just bought RC8T with a Go .21-spec-3port engine with red head on it.Running 30% Sidewinder fuel.I'm new to these engines and am having issues and getting fustrated.After buying,I tore it down cleaned checked and rebuilt everything in the power plant.First off it starts great and idles fine.I'm having problems getting the temps up, I lean it out to get temps up and it seems to be starving for fuel and stalls out.Richen it up a little and it runs fine but after about 10 minutes temps only at 160 F it pukes the O'donnell 97T plugs that I'm using.The plugs are still clean and new looking but the wire is breaking about 2-3 coils up in the plug.
I'm hoping this is enough info for some help/suggestions with my problems.
thanks............gosharpie97.
you may have the .2mm break in shim still in place. If so remove it. set the lsn and the hsn both to flush. Then turn hsn in 1/2 turn and lsn 1 full turn and adjust from there. also make sure your idle gap is set at roughly .1mm and if you decide you don't want the engine let me know.