Originally Posted by
JCarr
Ok, I had my first chance to run the new software this past weekend. What i am experiencing is what i can best describe as turbo lag. I hit the power comming out of a corner and teh car is really slugglish then after about 3ft it starts to really take off.
Here are my settings:
Car: Tam 416
FDR: 6.12
Track: 120x72 fast but with a few tight corners
Drag: off
brake: 100
nw: 56
motor: bl-fw
tp: 3
cut off: 6.430
push: off
timing: 30
turbo: 10
delay: .2
start: 4989
end: 14997
ramp: 2
I tried changing the timing to 40 and boost to 15, it helped some but still had the lag. Temps after 6 minutes 140 and 135 after the change. What do the gurus think, am I getting too much timing too soon? Should I set the delay back a little? Thanks for any and all advice.
I would try two different things.
1. Turn the turbo up and delay to 0
2. lower your end rpm as already suggested and turn your delay up.
You could also turn your boost up. It is a bit conservative.
I run my car both ways I have suggested. It depends on the track. I like option 1 on short technical tracks and option 2 on big flowing tracks.