R/C Tech Forums - View Single Post - Problem with: 4PK--MM pro--Servos not functioning correctly.
Thread: Problem with: 4PK--MM pro--Servos not functioning correctly.
View Single Post
Old 05-14-2010 | 09:48 AM
  #2  
JayL's Avatar
JayL
R/C Tech Elite Member
 
Joined: Mar 2006
Posts: 3,111
From: Ca
Default
are you in HRS mode? this mode does not work with analog servos

try ppm mode if that is the case

or

up the voltage in the MM using castle link to 6.4v
also IIRC some other setting in there has something about high amp draw servos
Last edited by JayL; 05-14-2010 at 09:49 AM. Reason: MM
JayL is offline  
Reply