View Single Post
Old 05-13-2010, 02:42 PM   #1246
Dragonfire
Tech Champion
 
Join Date: Feb 2003
Location: Sydney, Australia
Posts: 5,310
Trader Rating: 1 (100%+)
Default

Quote:
Originally Posted by Frankgw View Post
Thanks TEAMWAVE for the quick response.

I have tried holding down the button for longer. No LEDs light up.
Looks like it could be a faulty button.

Is this a common problem?
Is it possible to fix?
Do you have a repair service in the UK and how much would it cost?

Sorry about all the questions. It would be a shame to bin it if it's only a button problem. I would like to use it if possible, the new firmware sounds great!

Thanks again, Frank
This may be a stupid qusstion but I noticed you never mentioned turning the esc on or off. Did you hold the button down THEN turn the esc on? Also I have noticed that sometimes you get rubbish in the switch and it stayz on all the time. Is your switch always on?
__________________
Blade: Andro Treiber H 79g AN
FH: Donic Bluefire M3 Max Blk
BH: Donic Bluefire M2 Max Red
Powered by Falco
Dragonfire is offline   Reply With Quote