Originally posted by Diesel Racer
Rookie, first things first, double check the thickness of shim that you placed between the brass collet and engine output bearing, this should be 0.5mm. When checking your A & B dimensions that should be with just the thrust bearing installed not the 2 small ball bearings.
Good luck
Mark
According from my caliper..........I had 0.47mm, 0.48mm and 0.53mm shims, no 0.50mm exact thickness SHIM......do you think Serpent can send me a exact 0.50mm shim, and do you guys think that is the different...? I used a 0.48mm thickness, should I get 2 more 0.01mm shims to form 0.50mm?
Also, I think it is my $50 cheapy EBAY Caliper....