Originally Posted by
Tony Turbo
UPDATE!
I got it to fit, be being clever lol.
All I did was take off the body mount plates from under the chassis, and put them on top of the chassis. This gave me an extra 8mm of height that I needed. It doesn't sound a lot but it's enough, and if I want to go higher I can by putting some washers or spacers underneath. I might do that to the rear anyway to give it more of a nose down look.
Don't worry, I am going to use the correct bolts, this was just a test
Tony,
That is a quick good solution!
I did notice that your chassis is very close to the ground. What is your ride height? For parking lot racing I tend to increase my ride height, more than normal. For example, i would use 8 to 10 mm in the front and 12 to 14 in the rear.