can someone clarify something for me? I have never seen a hudy break in bench. But from what people say and from what i understand it's just a stand to put the engine on, a place for the fuel tank and a propeller for a load.

Is that it? does the break in stand vary the load and adjust the throttle for you? Do you put a servo on the stand? Or do you hand control the throttle? And the load stays the same with the propeller right?

So technically you could still not break in the engine right with the break in stand since you would have control over throttle inputs right?

If this is the case, I don't see much of an advantadge over putting it in my buggy and idling it on the box while varying the throtle.