R/C Tech Forums - View Single Post - 1/12 forum
Thread: 1/12 forum
View Single Post
Old 02-25-2004 | 05:20 PM
  #6906  
Mike D's Avatar
Mike D
Tech Master
 
Joined: Sep 2001
Posts: 1,095
From: Maryland
Default Re: Rugrat
Originally posted by Fiddle Fadel
Mike D

Thanks for your setup.
Please clarify where you ballstuds are located on the servo saver.
Outside top, outside middle?

Thanks
Dave
Dave - On the Kimbrough mid-size servo saver I am using the lowest holes closest to the servo saver mounting screw. I just cut the excess material off the servo saver... this picture might help:

Front end/servo saver picture
Mike D is offline  
Reply