View Single Post
Old 02-23-2004, 07:16 PM
  #7088  
forty6
Tech Master
 
forty6's Avatar
 
Join Date: Dec 2002
Posts: 1,922
Default Re: Re: Re: Re: Re: MIP CVD Installation

Originally posted by Randman
Didn't think so, but 1 person seems to be having the problem.

I'd check and make sure the bearings are pushed all the way into the hub.
I'm not really sure the he is experiencing the binding. When you tighten the wheelnuts, it is the EZ hub hex that is pushing up against the wheel. For the axle to be "pulled" against the inner bearing or the hex to be "pushed" against the outer bearing, something must not be seated right just like Rand had suggested.
forty6 is offline  
Reply With Quote