This is it! I have been waiting a long time for it.
I do have a few suggestion for the new chassis.
A simpler and cleaner setup will be good.
1)A new chassis similar to the new Xray link 1/10 with 6 battery cut-out down the center to cater for those lipo with small nodes at the bottom. This will allow the battery to sit lower on the chassis.
2)For the front width, can make use of the wider arm mount plate or design the front chassis wider and use smaller extension plate to further adjustment the width from 215mm - 230mm
3)Bumper mount hole. Additional holes to allow adjustment of the bumper, +/-5mm to better fit the bodyshell.
4)Rear body post. Design the chassis similar to using nerf plate at the link side before the rear tires or extend the chassis brace to mount the post further apart.
Hope to see the real final chassis soon. +1 order for me!!