Originally Posted by
Ei8ht
Just a couple weeks ago I was setting the failsafe. I set it to full brake and didn't think much of it. As little while later I was testing servos and noticed that my throttle servo needed to be reversed because it was braking when I was giving it throttle. What I didn't know was that it also reversed the failsafe! So if it lost the connection it would just pin it! I even ran it like that once, luckily I cought it before anything bad happened...
Very good point! I always make sure I go in and set everything up after I first bind it, and then re-bind it after all settings are close.
Originally Posted by
tc5 man
when i go to half brake and bind the, spekum i make sure my throttle servo is in reverse but when, im at netual the brake isnt on. if i turn my radio off with my receiver, battery pluged in it will go to half brake.
jammincrazy i try to just set the, speckum up at netual but i have done that before and the fail safe doesnt work.
Failsafe doesn't work??? It should work the same way as it does with it set to brake. It will just go into neutral instead of brake. IE: you should be able to switch the radio off with your receiver powered on, and the controls will sit in neutral(still powered on).