Originally Posted by mlight13

I need some help with setup. When I built my car, I adjusted the droop to 7mm front and 6mm rear due to me driving on bumpy asphalt. Once it was all put together, and the ride height and camber were set, I noticed that it looked unbalanced when I lifted the chassis slightly to check the uptravel, one wheel lifts off the ground 1/2 inch when the other is still on the table. I adjusted them to now rise off the table evenly but one droop screw is almost all the way out and the other is screwed all the way in. I also added weights to offset the weight of my Lipo. Which is the best way to go...even droop measurements on both sides or have both wheels lift up at one time? Thank you.