Right, my scanner dont want to work so ill just type this out
General
Caster 4*
Front Drive Spool
Wheelbase FF 1mm FR 2.5mm, RF 2.5 RR 1
Toe 1* out
Front and rear wing Rubber Asphalt
Vertical Ackerman Middle
Radial Ackerman 10
Top deck Rubber Ashpahlt
<-- Kit top deck ?
Front
Camber 1.5
Droop 35.5mm
Top shock hole 4
Bottom Hole 2
2mm inside link, 0mm outside in hole 3 on standard plate
2.5mm ARB link (mounts upside down)
<-- not sure what you mean by upside down ?
1.5mm front roll bar
FF 0mm (if more mid corner needed go to 0.5mm)
FR 0mm
inside hole on steering block
Rear
Camber 2
Droop 33.5mm
Top shock hole 3
Bottom hole 2
1.5mm inside link, 1mm outside (want to try 1.5mm) hole 3 standard plate
2.5mm ARB link (mounts upside down)
1.25mm rear bar
RF 1mm (prostock i run 0.5-0.8mm then 2.5 overall toe)
RR 3.4mm
Roll centers Mid low all round
Shocks
12.35mm (body to ball joint)
1.1mm piston (tamiya 3)
400CST front and 350cst rear (MM Oil)
3.0 Xray front springs and 2.6 Xray rear
General
SP V3 4.5 turn, geared at 100/26
Muchmore 5200 50c lipo
LTC shell (a must really)
Sorex 32's with tweak
Car was going quite well with this setup and could easyly do low 18's high 17's on a very dusty track.