Originally Posted by ixlr8nz

I did some back to back testing today with 324 and 410. I found that with the same settings 324 had much better acceleration but much less top speed. 410 was the opposite and had great top speed but not so much acceleration.

I feel neither of these options are that good and would be great to see an option with the acceleration of 324 and the top speed of 410. To be honest 324 had a better feel and when you pull the throttle it gives good throttle response. 410 had nothing till you were 3/4 throttle.

I used the following equipment on a huge track:

Xray T2-008
6.2:1 gear ratio
Speed Passion V3 13.5 with 10 degrees on the motor
Motor temp- 57 degrees was the highest I saw
9-8
12-8
13-9 (or there abouts)
14-1
15-2

To be honest I'm a little disapointed about the way Speed Passion deals with its software. They could do much better by letting the general public know whats going on and always give people the opportunity to try the new software(even if its a little risky). Its wrong to have people speaking about software that you can't even get your hands on, and I can tell you its putting people off.

regards
Mike