Hoping someone could help me out - I downloaded the new software (232 in think) and put on a FDR of 7.0 just to try it out last night and the motor heat (with the basic 17.5 setup that came attached with the download) was through the roof after just a couple of 5 sec flat stick bursts - almost hit 70 degrees - basically wondering what I am doing wrong as the setup is exactly as per recommended and the ratio is more than the recommended. P.S. I am running a 21.5 not a 17.5 not that I thought that should matter - if someone can send me a setup they have tried on a mid/large on road track with a bit of grippy surface I would appreciate it - PM's are best as I dont check this thread as regularly as I should. Cheers