Originally Posted by
Pattojnr
dont Tranny's have other things that go un-noticed till its too late ? !
seriously , every motor purchased, i pull down. its safer that way. not only for shavings, but some tolerances also. i have noticed of late a few tight piston pins, which can cause all sorts of problems while running in. and can damage a piston on first run. also dont be too complacent, one was an OS engine, and a couple of nova engines.
You must be very unlucky!! I have never had a problem with OS engines,
thinkin seriously about a Sirio CLB7, also the werks B5 dont sound too bad and good value. (lookin for a bit better value for my buck) Apparently the werks B5's are made in italy, where Sirios are made, do you know about these engines?
